Image of Installed Gauge Panel

This DIY write-up is for installing the VDO gauge panel kit put together by J. Maddux and LeatherZ.com.  While his instruction write-up was very helpful during my installation, certain parts were vague or could have used pictures to take some of the guesswork out of the installation.  So, here's my humble attempt at it.

1) Prewiring of the Gauge Panel
2) Installation of Pressure Sender
3) Installation of Temperature Sender
4) Running the Signal Wires into the Car

Now, take a break and go wash your hands.  The rest of the stuff happens inside the car so you want clean hands!

We're going to get into the wiring of the car so make sure you have your key is in the off position.  That means no more radio from here on out.  The other thing to
remember is that pretty much every piece of exposed metal in the car is connected to ground so be careful if you've got a hot wire near metal.

5) Removing the Front Console
6) Removing the Glovebox
7) Feeding Power to the Gauges
8) Testing Your Setup

Ok.  All done!  Enjoy your gauge panel!

Special thanks to J. Maddux for putting together the kit and instructions.